Motorized back gauge MZD OP

Motorized back gauge is used for positioning the material in the correct position without being held by the operator. The back gauge drive is provided by one or two ball screws and accurate control. The front abutment surface (fingers) are optional depending on the thickness of bent and customer requirements They can be supplied as folding fingers or swivel fingers made of spring steel.
The storage area of the back gauge can be equipped as needed by ball nests, side guides left or right. For engine with the MZD control the use of one of controls is required NT3 or FF101.

• motorized back gauge with turn fingers in steel plate
• range of motion to 1000 mm, 1500 mm, 2000 mm, 2500 mm, 3000 mm